MATERIAL SAFETY DATA SHEET
Issue Date: 04/14/12
==================================================================
SECTION I - PRODUCT IDENTIFICATION
Eager Plastics Product Number
EP5301 Resin EP5883 Resin EP7320 Resin
EP5310 Resin EP6110 Resin EP7328 Resin
EP5312 Resin EP6112 Resin EP7330 Resin
EP5340 Resin EP7112 Resin EP7346 Resin
EP5341 Resin EP7120 Resin EP7347 Resin
EP85-215 Resin EP7122 Resin EP7349 Resin
EP5347 Resin EP7130 Resin EP7350 Resin
EP5351 Resin EP7136 Resin EP7356 Resin
EP5353 Resin EP7140 Resin EP9004 Resin
EP5356 Resin EP7150 Resin EP9027 Resin
EP5360 Resin EP7156 Resin EP9028 Resin
EP5361 Resin EP7220 Resin EP9043 Resin
EP5364 Resin EP7222 Resin EP9078 Resin
EP5365 Resin EP7230 Resin EP9087 Resin
EP5410 Resin EP7240 Resin EP9096 Resin
EP5411 Resin EP7310 Resin
Product Class: Epoxy resin in reactive diluent
C.A.S. Number: Mixture
HMIS Rating: Health = 2 Fire = 2 Reactivity = 2
==================================================================
SECTION II - INGREDIENTS
Maximum Exposure
Ingredients CAS # Content Limits
Epoxy Resin --- 87.0 % None assigned
Butyl Glycidyl Ether 2426-08-6 13.0 % 25.0 ppm
==================================================================
SECTION III - PHYSICAL DATA
Boiling Point: N.A. Vapor Density: Nonvolatile
Volatile %: 0 % Specific Grav: 1.13
Evap. Rate: Nonvolatile
Appearance: Straw colored liquid.
==================================================================
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Flammability Class: 3A Flash Point: 157 Deg. F. LEL : N.A.
-EXTINGUISHING MEDIA:
Foam, carbon dioxide, dry chemical or fog.
-SPECIAL FIREFIGHTING PROCEDURES:
Firefighters should wear goggles and self-contained breathing
apparatus to avoid inhalation of smoke or vapors.
-UNUSUAL FIRE & EXPLOSION HAZARDS:
None known.
==================================================================
SECTION V - HEALTH HAZARD DATA
-PERMISSIBLE EXPOSURE LEVEL:
The OSHA PEL and the ACGIH TLV for butyl glycidyl ether
is 25 ppm for an 8-hour TWA.
-EFFECTS OF OVEREXPOSURE:
Inhalation - Nasal irritation, central nervous system depression lung
injury.
Eye contact - Mild to moderate irritation, possible minor temporary
corneal injury.
Skin contact - Mild irritation. May be a skin sensitizer.
-EFFECTS OF OVEREXPOSURE:
Skin absorption - Not likely to be absorbed in toxic amounts.
-FIRST AID:
Eyes - Flush with plenty of water and get medical attention.
Skin - Promptly wipe clean with paper or cloths and wash with soap
and water. Remove and wash any contaminated clothing before reuse.
Inhalation - If ill effects occur remove person to fresh air, keep that
person warm and quiet and get medical attention promptly.
Ingestion - Not likely a problem. If large amounts are swallowed,
promptly induce vomiting and get medical attention.
-PRIMARY ROUTE(S) OF ENTRY:
Inhalation, ingestion, skin and eye contact.
-TOXICOLOGICAL INFORMATION:
This product does not contain 0.1% or more of any substance which is
listed as a carcinogen by NTP, IARC or OSHA.
BUTYL GLYCIDYL ETHER: LD50 (ORAL/RAT) 2050 MG/KG;
LD50 (DRML/RABBIT) 2520 MG/KG; LC50 (INHL/RAT) 1030 PPM/8H
==================================================================
SECTION VI - REACTIVITY DATA
STABILITY: [ ] Unstable [x] Stable
HAZARDOUS POLYMERIZATION: [ ] May occur [x] Will not occur
-INCOMPATIBILITY: Strong oxidizers, acids, bases and epoxy hardeners
under uncontrolled conditions.
-CONDITIONS TO AVOID: Heat and warm storage.
-HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide, carbon dioxide, smoke.
Other possible products unknown.
==================================================================
SECTION VII - SPILL OR LEAK PROCEDURES
-STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED:
Ventilate area. Absorb spill with suitable absorbent material and
place into a closed container. For large spills, dike area and pump
into closed containers. Prevent this material from entering waterways.
Wear protective equipment during cleanup.
-WASTE DISPOSAL METHOD:
At this time, this material or its containers would not be considered
hazardous wastes as defined under the federal RCRA regulations
(40 CFR 261) if discarded. Care should be taken to ensure that the
material or its containers are disposed of in an approved facility in
accordance with current federal, state, and local regulations.
For further information, contact your state or local waste agency or
the United States Environmental Protection Agency's RCRA hotline
(800-424-9346 or 202-382-3000).
==================================================================
SECTION VIII - SPECIAL PROTECTION INFORMATION
-RESPIRATORY PROTECTION: Should be worn to avoid breathing spray mist,
heated vapors or if TLV is exceeded.
-VENTILATION: Local exhaust and general ventilation recommended.
-PROTECTIVE GLOVES: Chemical-resistant plastic or rubber.
-EYE PROTECTION: Chemical goggles.
-OTHER PROTECTIVE EQUIPMENT: As required to prevent wetting skin or clothing.
==================================================================
SECTION IX - SPECIAL PRECAUTIONS
-PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: This material may cause
sensitization. Do not get in eyes, on skin or clothing. Do not allow
contaminated clothing to contact skin. Avoid contact with vapors or fumes.
-OTHER PRECAUTIONS: Wear protective equipment.
==================================================================
SECTION X - SUPPLEMENTAL INFORMATION
-REGULATORY INFORMATION: None.
-SARA & WHMIS HAZARD CLASSIFICATIONS: This material has been categorized
as having the following hazard(s) as defined by SARA Title III
regulations (40 CFR 370): acute, fire. CANADIAN WHMIS CLASSIFICATION:
B3,D2A,D2B
-SARA SECTION 313 LISTED INGREDIENTS: The following ingredients in this
material are subject to the reporting requirements of section 313 of
SARA and 40 CFR 372 [see Section II for percentage of ingredient(s)]:
-DOT PROPER SHIPPING NAME: NON-BULK: NOT REGULATED BY DOT HMR BULK:
COMBUSTIBLE LIQUID, N.O.S., (BUTYL GLYCIDYL ETHER) COMBUSTIBLE LIQUID,
NA1993, III
-MSDS PREPARATION INFORMATION:
PREPARED BY: Product Safety & Compliance Department Research Triangle Park,
North Carolina, 27709
This information is provided in good faith and is correct to the best of
Eager Plastics' knowledge as of the date hereof; however, Eager Plastics
makes no representation as to its completeness or accuracy. Customers are
encouraged to make their own determination as to the suitability of this
product for their purpose prior to use. Eager Polymers disclaims
responsibility for damages of any kind resulting from the use of this
information.
THERE ARE NO WARRANTIES OR REPRESENTATIONS, EXPRESS OR IMPLIED, INCLUDING
THOSE OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE WITH RESPECT
TO THIS INFORMATION OR TO THE PRODUCT IT DESCRIBES.
